Position over anchor bolts and set on leveling nut washers.Place leveling nuts and washers on anchor bolts.excessive stresses in the anchor bolts.Large spaces between the pole base plate and the concrete can cause.When leveling nuts are used, the bottom of the lowest leveling nut should not be more than 1” from the concrete surface.The bolt circle template provided conforms to the bolt circle of the pole base.is not responsible for the structural integrity of the system if anchor bolts are supplied by others. Contact the factory for the correct size and strength.Anchor bolt diameter, length, and psi are specifically selected to withstand load limitations listed in.The concrete foundation must be designed by a qualified engineer with knowledge of the local soil conditions. The purchaser and installer must provide electrical groundings and warnings about electrical hazards in accordance with applicable codes. Grounding & Protection Against Electric Shock is not responsible for any damage that occurs during or after installation, or for any structure that has been modified by the purchaser or used in a way other than our application recommendations. It is important to note this is not a comprehensive installation guide, and installation contractors must be relied upon for equipment and practices that meet the conditions of each job location. Here is a high-level description of the installation of our structures.
0 Comments
Leave a Reply. |